3/23/2023 0 Comments Polk audio bar 6000![]() How do I erase previously learned remote control commands? In this rare event, simply turn off the power (switch located on the back of the bar), wait a few seconds, and then turn the power back on. My SurroundBar 6000 was responding to commands, but now it isn’t. Program the SurroundBar 6000 to respond to your existing remote (see included instructions). Use the touch-sensitive buttons on the front of the bar. There are three ways to control your SurroundBar 6000: Note: RF only remotes will not work with this system. In this case, please use the remote control provided with the SurroundBar 6000 product or try a different universal remote control. However, there are likely some cases in which the bar will not be able to learn your remote codes. There are many remote control formats, and we have done our best to make the SurroundBar 6000 compatible with the most popular brands. Why can’t I successfully program the SurroundBar 6000 to respond to my remote control? If the sound from your SurroundBar 6000 is strange or distorted, then check the audio menus of whatever source(s) are connected to your SurroundBar 6000 and make sure any audio processing is turned off. Your SurroundBar 6000 requires a clean, unaltered stereo or Dolby Digital signal for proper audio performance. If that is your situation, your local electronics store will have cables that meet your required length. We did our best to provide a cable of adequate length however, there might be a few setup instances in which the cable may be too short. What if my provided optical cable is too short? Use the RCA audio outputs (white/red pair) on your TV (or other source) and connect directly to the SurroundBar 6000 using a 3.5mm to Stereo RCA analog adapter. Use the headphone output of your TV and connect directly to the SurroundBar 6000 using a 3.5mm stereo analog cable. Use the optical output of your cable/satellite box and connect directly to the SurroundBar 6000 using the optical cable. You have several options for connecting your audio: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |